Spline_(device)

Spline is used to denote either of two quite different design elements.

This short section requires expansion.

Flat spline or lath

A spline consists of a long strip fixed in position at a number of points that relaxes to form a smooth curve passing through those points.

Before computers were used for creating engineering designs, drafting tools were employed by designers drawing by hand. To draw curves, especially for shipbuilding, draftsmen often used long, thin, flexible strips of wood, plastic, or metal called a spline (or a lath, not to be confused with lathe). The splines were held in place with lead weights (called ducks because of their duck like shape). The elasticity of the spline material combined with the constraint of the control points, or knots, would cause the strip to take the shape which minimizes the energy required for bending it between the fixed points, and thus adopt the smoothest possible shape.

One can recreate a draftsman\'s spline device with weights and a length of thin stiff plastic or rubber tubing. The weights are attached to the tube (by gluing or pinning). The tubing is then placed over drawing paper. Crosses are marked on the paper to designate the knots or control points. The tube is then adjusted so that it passes over the control points[1].

In 1946 mathematicians started studying the spline shape, and derived the piecewise polynomial formula known as the spline curve or function. This has led to the widespread use of such functions in computer-aided design, especially in the surface designs of vehicles. I. J. SchoenbergI. J. Schoenberg, Spline Functions and the Problem of Graduation PNAS 1964 52: 947-950 pdf gave the spline function its name after its resemblance to the mechanical spline used by draftsmen.

The origins of the spline in wood-working may show in the conjectured etymology which connects the word spline to the word splinter. Later craftsmen have made splines out of rubber, steel, and other elastomeric materials.

Spline devices help bend the wood for pianos, violins, violas, etc. The Wright brothers used one to shape the wings of their aircraft.

Rotating spline or gearing mechanism

The word spline can also denote one of a series of ridges on a driveshaft which mesh with and equalize the rotation speed of a mating piece, thereby transferring torque. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear. Manufacturers typically cut such splines with a broach.

Splines on the end of a manual transmission input shaft.

References

This metalworking article is a stub. You can help Wikipedia by expanding it.

This article is licensed under the GNU Free Documentation License. It uses material from Wikipedia